Builders Hardware
Dock System Hardware Pipe Holder-3 In.
Designed to allow the dock to slide up and down with the water level. Used on the inside or outside face of your stringers to secure the dock into place using a 3\" diameter pipe.
Merchant: Home Depot
Dock System Hardware Angle
Angles are used in conjunction with washer plates, and sometimes even backup plates. We use angles to connect stringers and supports inside a dock.
Merchant: Home Depot
Dock System Hardware Male T Connector
The single \"T\" Male bolts to the side of the dock where a finger or ramp may attach, or where an outside corner male can\'t be used. It has one 1/2\" thick tab with a hole for a 3/4\" pin and is used with a single \"T\" female to connect sections of the dock together.
Merchant: Home Depot
Dock System Hardware Chain Retainer
Bolts to the side of the dock. Uses weights and chains to hold the dock in place. Accommodates 1/4\", 3/8\", and 1/2\" chain.
Merchant: Home Depot
Ledger Board Vinyl Flashing 2 - 5 Ft. 4 In. Sections (Overlap 4 In.to Make A 10 Ft. Section)
Our Patent Pending DuraFlash Vinyl Flashing is made of exterior grade polyvinyl chloride for use with all pressure treated lumber. It is aesthetically pleasing and responds well in all applications.
Merchant: Home Depot
6 In. Bilge Hose, 3/4 In. With Clamps Bilge Pump & Accessories
Electric bulge pump installation kit. 6 Ft. hose with 2 clamps, part of the Complete kit to install manual bilge pump with 3/4 In. or 1-1/8 In. I.D. hose outlet.
Merchant: Home Depot







